-
Junior Member
- Rep Power
- 203
- Reputation
- 65
Motor Woes
Hi all,
I'm using a DM500s with a 2A power supply, pli-jade, a moteck SG2100A and i'm moving a 1m offset dish.
At this point, i'm not even trying to get a signal, i'm just trying to get the Dream to move the dish, but it won't.
The motor moves okay via the buttons on the unit itself, but I can't get the dream to control it. I've tried 1.0, 1.1, 1.2, gotoX switched off, and instructions from this thread... to no avail.
UPDATE: I've disconnected the LNB (Dual Sharp 10700) and the motor now behaves as it should.
Any ideas ?
Last edited by vbthanks; 15-05-11 at 03:20 PM.
-
Junior Member
- Rep Power
- 203
- Reputation
- 65
The Following User Says Thank You to vbthanks For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks