Thread: Azbox

Originally Posted by jgarg

I was wondering if anyone else has upgraded their Azbox with the latest RTI firmware.I have found it to be excellent,but cannot get the internal card reader to read my goldie.
Anyone have any ideas?
BTW ,these boxes (premium plus) also have a noisy fan and I was able to solder a 24 ohm resistor to the red cable and this has made the fan much more quieter.

Will the card reader read an Irdeto 2 card? I'm using the factory firmware on my Ultra and it reads goldies and IR2 cards with the OpenCAS

Leroy

Originally Posted by irdeto2engineer

Will it read the IR2 5.7 version cards too?

I doubt it. I don't have any to try anyway.

Originally Posted by jgarg

I have a usb with original firmware that I can boot directly and it does read the card.

Maybe no card reader support with RTI firmware? Another thing, I1 is getting old so I'd be surprised if the EMU supports it.

The factory firmware isn't that bad and actually works fine. Little slow on clearing CS channels in the past, not sure now, but all in all it works, blindscan is not the fastest, display's 4:2:2 feeds and reads goldies.

Leroy

Originally Posted by irdeto2engineer

Will it read the IR2 5.7 version cards too?

I am using standard f/w with Muticas it doesn't read IR2 5.7 but reads IR 4.1...I haven't tried it in Enigma custom s/w...I

Originally Posted by slippery49

ok I tested my ir2 card this morning and it reads and performs fine, that is with the E2 Spaze Fix.

Just running oscam.

Can you cofirm the IR2 version which works with E2 Spaze Fix?...V5.7 & above seems to be bit tricky to get camkey...