-
How to ?
Can anyone give me a rundown on programming & deleting w/less PIRs on a NX16. Thanks to whoever
-
can send you instructions if you want watchdog or make you a to do sheet
Thanks Tas - a simple cheat sheet would be good. I'm sure its not hard but you never like doing that initial fumbling in front of a client. Is it in the manual ?
do you know what receiver it is Watchdog?
Its in the NX448 Reciver details pm me and send me your email address and i can send it to you
its a bit long winderred to talk through learning one on as you need to know how the reciver has been setup which module it is programmed as so you need to check dipswitches and compare with install manual then you need to intergate to see from what zone up have been made wireless zones then nominate zone and specs then enroll etc
deleting is easier but you still need to know what module the radio reciver has been programmed as
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks