It is all in the book
Installer code then 1 #
Zone number #
9 digit code on PIR#
I need the code to install two PIR RF940 in me Bosch solution . I have the cc408 and the control panel cp508 with RF3212E.
I have install the two PIR, but the alarm does not recognize
according to the instructions I need to put the serial number off the PIR in the keypad to recognize the pir.
That code should be put to the pir?
1234# and ?
Thanks.
Regrads...
Look Here -> |
It is all in the book
Installer code then 1 #
Zone number #
9 digit code on PIR#
Thank you for your reply. But I don't have the instructions guide and I would appreciate if you could tell where can I find it.
The problem is that the alarm system has been five year off. Now I have install the PIR but the alamar system does not recognize it although I have install new batteries. I have reset the alarm and continue without recognizing it. I would like to know in which number of zone I have to introduce the PIR.
Also I would appreciate if you could tell how to eliminate zones because there is a lot of zones occupied and the control panel shows that the whole numbers are on except the numbers 3 and 7. The alarm only have the control panel, 2 PIR and the RF3212E.
I have tried to introduce a PIR in the zone 3 and another PIR in the zone 7 but in the sensor proofs does not appear connected.
Thank you very much for all your help. Kind regards.
You need to call in a professional
Thanks watchdog. Itīs the CC488, nor CC408
For de CC488
Installer code then 0 #
Zone number #
9 digit code on PIR#
Bookmarks