If it goes funny again at the bottom of the digitiser where the home button ribbon runs along and joins the main ribbon - it needs some sort of insulation (sticky tape) - I'll post up a photo tomorrow - currently at work
Hi all I just changed the digitizer on this iPad mini2 and all worked ok till the owner booted the old iPad mini 1 then this unit seamed to be possessed it would random type stuff on the screen. I thought it may have a bad digitizer but now the other iPad has gone this one seams ok. I have typed this on it without out a hitch. Is it possible that the old one was interfering because they were on the same network? Both have the same version of software and are on the same account. One is Called eg Daves iPad the other is Freds iPad.
SS Dave
Death smiles at everyone. Grumpy old men smile back.
Look Here -> |
If it goes funny again at the bottom of the digitiser where the home button ribbon runs along and joins the main ribbon - it needs some sort of insulation (sticky tape) - I'll post up a photo tomorrow - currently at work
有段者
SS Dave (27-06-16)
Thanks freakee1
It did appear to be around the letters T,H,Y. it is still working OK at the moment a pick would be good
Thanks
Death smiles at everyone. Grumpy old men smile back.
Here you go Dave, the yellow tape...... It is definitely needed !!!! Also make sure it covers the connection to the glass (digitiser)
Last edited by freakee1; 27-06-16 at 04:45 PM.
有段者
SS Dave (02-07-16)
Hi freakee
Thanks for the pic
It had tape as pictured so i covered the entire lower part from just below the clear part to the just on the double sided tape with the same type of tape and that seamed to sort it
Dave
Death smiles at everyone. Grumpy old men smile back.
freakee1 (02-07-16)
Bookmarks