Bosch Solution 2000 Sensor not triggering immediately (URGENT HELP)

[somerset7]

The alarm itself works fine, my problem is, when you walk in front of a PIR Sensor, the blue indicator comes on meaning the PIR was triggered, but the alarm doesn't activate until you walk out the the way.

I want it so, as soon as the blue indicator lights up on the PIR Sensor, the alarm starts counting down to put the code in.

Because, when it's armed and you walk in front of the sensor, the sensor turns on, but doesn't send a report to the alarm itself until you get out of the way and the indicator turns off again.

[Monkeymitch7]

You will need the Installer Code to get into the programming to change the setting. It could be the pulse count and pulse count time causing the issue. Set both of these locations to 0 in the zone programming settings to set the PIR to activate the entry delay instantly.