Change your port maybe ????
Tagg
In CcCam I am appearing Offline for my peer . I never go offline.How do i fix this issue.?Seems to be port 12000 is closed.
I am using Motorolla cable modem-D-Link Wireless router524.DM 7020Si.
Look Here -> |
Change your port maybe ????
Tagg
is the port 12000 server on the local network or is over wan, if it's local then it should'nt have anything to do with router, maybe an ip conflict.
You coud try a different port number both the client & the server to see if it works.
Any port that I can use.?
I am not even sure It is a Port problem.because DM is connected to net.I can serch the net with DM .But peers cant see my cards and me online.
Just peers can not see me online.
I am telneting and pinging it is ok.
Did anybody had the same problem that can help here.
PS : CcCam works fine too.
LAN connected too/ Pc-DM-Wireles Router connected to each other
Have you checked the dreams IP address has it changed, can you check the config of the router for the ip address that you are forwarding port 12000 to & make sure it's the same as the dream.
maybe your modem has a new address.
Leroy
I am using no-ip and dyndns too no goo.
My IP adress is still the same.
xxxxxx.dyndns.tv
xxxxxx.no-ip.biz
I went to routers web face and opend port 12000 for my Dm on TCP and UDP
On the WAN side the IP address is given to the router by your ISP, this can permanent (static) or tempory (dynamic).
I think you can see what this IP address is in the home page of the router. this has to match the dynamic dns address.
Also in the virtual server page is were you configure the 12000 port forwarding, you must have the DM's IP address in were it says private ip address.
Hope this helps.
Just like that as you said Neutral..
If I give you my C Line (pm) would you be able to chack it? am i online or not
I am online now
but with no card..
I did send you my DNS STIO2
MR-MIXER, your router must have port 12000 tcp open for the WAN interface and port forwarding set up to forward port 12000 external to 12000/<your_dm_ip_address> internal.
As ST102 has stated, port 12000 is closed from the outside on your router. This is the first thing you must rectify.
You do know that most ISP's in OZ block port 12000 right? Worldwide too?
Simply change ports in /var/etc/CCcam.cfg on a 500 or /etc/CCcam.cfg on the others, but CCcam over the WAN sucks at best, try mbox
It is a hobby so mileage varies
Loving IPTV with XBMC and android M8
Join in the XBMCHUB community and visit me at http://tvaddons.ag/
DM shows 0 card ,and it is an issue
Bookmarks