I think you need to look for a good technician mate, LOL
the way you are going you gonna run out of dreams soon.
case 1
Flashed a dream 500s with PLI and I can't get Vertical channels ???
Case 2
Flashed another dream 500s with PLI and I can't get Vertical channels ???
Case 3
Flicked the 7020 off and now it's stuck on the loading screen ?????
Does any one else want me to fix there dream for them
When you do things right, people won't be sure that you have done anything at all
Look Here -> |
I think you need to look for a good technician mate, LOL
the way you are going you gonna run out of dreams soon.
My Marriage has nothing to do with it mate
MMMMmmmm Hang on, I was a good tech before i got married
When you do things right, people won't be sure that you have done anything at all
Are you using the same power supply mate? Im wondering if you have a voltage problem.
BTW Marriage has a tendency to shatter dreams.
Hi Buddy - I assume the LNB you are using is dual polarity. I recall there are some old LNBs that were single polarity once upon a time.
You probably have already done this, but I would suggest to check that you get horizontal and vertical with another STB, Hummy etc. - Also use only one STB to a single LNB feed i.e. do not do a loop through as this only works for 1 polarity.
1: running two subs on same lnb looped through
2: as per above
3: reflash
dont say linux if i wanted it id install it
Thanks Guys it was .............................2 boxes on the same dish LOL
Flashed the 7020 with PLI and she works but i am thinking it's the PSU but all the caps measure fine with the ESR meter might be time to do all the caps
When you do things right, people won't be sure that you have done anything at all
Bookmarks