German says..
UCO ERROR = Tuner Kapot.
it means Tuner gone...
Came home to the above error
From what I've found it looks like a tuner problem.
Can anyone confirm ?
If so, is it just a matter of cutting the legs off where its soldered onto the vertical board and then replacing it ?
Is there anything else to look out for/check ?
Thanks,
Jim.....
Look Here -> |
German says..
UCO ERROR = Tuner Kapot.
it means Tuner gone...
If it is working ,do not touch it
There are two ways out: you can change the tuner unit or change only the chip STVO299
Russian guy says solder this chip out...
If it is working ,do not touch it
I've changed the tuner,.. same error comes up.
Any other ideas ?
Well am getting similar problem i still dont know where the problem is it could be the power supply problem as well
look at my post below
Bump.
Is anyone on here able to fix these, or know where I can get it fixed, or suggest any further checks?
Thanks,
Jim.....
I did a 7020 a while back and i am sure the LNBP21 IC was what was causing most of the tuner grief
When you do things right, people won't be sure that you have done anything at all
The LNBP21 is just a voltage reg but it cause lots of different trouble, if I remember right it should be located on the M/B under the hard drive.
I found this on the net
To the left of the seated C60003 22UF 25V
It was a bout 2 years ago i did the repair lol
worth a test with the multimeter
When you do things right, people won't be sure that you have done anything at all
You know what i think it was z80 who put me on too the IC
When you do things right, people won't be sure that you have done anything at all
Bookmarks