My NetworX NX-16 alarm work as it is supposed to after it has been physically disconnected and re-connected back. But the technician was not able to turn off the service light. Any help is appreciated.
Look Here -> |
Yes, * 2 will tell us. If the panel has been powered down it could be that the Time/Date is not set, or could be it was monitored and now is not but has not been programmed accordingly.
Paul
Bad tech, call them back, the service light should be cleared.
bss904 (06-12-09),intelliGEORGE (06-12-09)
And when he comes back make sure you have a master code and if not get him to program one as this will help you to set date and time as these have to be reset when panel is powered down. And of course a user manual is handy as it explains how to find a fault when the service light is on but by the looks of it even your tech has no service book or in actual fact very little knowledge of the product you paid him to service.
My old saying read the instruction manual and 99% of your answers are covered
intelliGEORGE (10-12-09)
Thanks guys. I'll try the * 2 thing and see what I can find.
When I do the * 2 thing, the service light and the 8 blink. It indicates that it was the system date and time issue. It is now fixed. Thanks for all the help guys.
Bookmarks