No your diseqc settings are under the LNB settings. ie LNB1, 2 etc.
Leroy
A friend of mine has asked my help to connect his
Ku band & C Band dish using Diseqc/4x4 Multiswitch to Dm500s
His setup is as follows
C Band dish which is driven by actuator
Ku band currently is fixed position.He wants to buy H-H motor to automate ku band dish as well.
By connecting 2 lnb inputs into mutiswitch is it possible
to drive the H-H motor of kuband dish using DM500s receiver.
When i went into DM500s setup mode it is currenlty setup as "Non standardConfiguration..." do i need to change this one to Diseqc?
Location: Sunny Perth
Look Here -> |
No your diseqc settings are under the LNB settings. ie LNB1, 2 etc.
Leroy
Last edited by LeroyPatrol; 11-12-09 at 11:14 AM.
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Helpful pics there, Leroy!
LeroyPatrol (10-12-09)
Done. I did a cut and past and changed the pic number but the 2-5 pics had .jpg in upper case!
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Thanks leroy.
Leroy,
I tried as you suggested when i tried driving the hh motor using DM500s i got a message the motor moving to 156E the message stayed for a while i rebooted the machine it went to default position 152E then when i tried moving the motor again
the SNR stayed at 65% AGC 0 BER 0.I tried rebooting DM, removed the diseqec settings now i don't get any signal lock at all as the AGC remains 0%.
Don't know if i have broken the DM by trying diseqc.Any ideas?
Location: Sunny Perth
When do the loopback from my humax receiver i can lock signals not sure if one of the parts is broken probably because of which DM500s is unable to get power to the lock signals??Any ideas how to fix it?
Location: Sunny Perth
sounds like no power to the LNB from the DM500. Is this turned on? If so you should get a meter on to see if you are getting 14V/18V when switching between TPs with different polarities.
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
When the cable from LNB is directly connected to DM500s iam getting
SNR 61% AGC 0 BER 0 no lock.When i connect the cable to Humax & do loopback i get SNR 80% AGC 90% BER 2.5...
Location: Sunny Perth
have you confirmed in your lnb settings that the LNB Voltage is set to H/V and also measuered the output with a multimeter? There are a couple of threads on this issue you'll have to search for. It's prob easier to by a new one at the price they are now.
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Bookmarks