I am trying to configure my DM800 with D2 and ASAT 3s. Satfinder is able to show me 3s but it does show signal when i select D2.
I know both are working because i had both configured on strong reciever.
Thanks,
Be nice to newbies, they have every right to make mistakes
Look Here -> |
Dish1 > C band pointing to AS 3s
Dish 2 > Ku band pointing to D2
DM bootloader version 72 > Pli Jade3
No moter
Anything else that can help ?
Be nice to newbies, they have every right to make mistakes
Made some progress finally, it had to do with the frequency, changed all three entries for LOF, LOF/H and LOF/H to 12706 and it started to show the signal.
If it works, i will post screenshots for both the settalite configuration.
Be nice to newbies, they have every right to make mistakes
Last edited by beer4life; 25-12-09 at 03:39 PM. Reason: Correction.
Yes, its different in dm800. Thanks for the thread. I believe I will have to wait till someone posts configuration about d2.
Be nice to newbies, they have every right to make mistakes
what lnb's do you have.?
if you have 11300. you will have to go to user defined settings and then enter it as 11300, 11300, 11700.
If you have universal you just go to universal setting in the dm800.
also have you set the diseqc to 1.0. and also allocated committed diseqc command to AA or AB as required.
Last edited by joffaa; 25-12-09 at 09:51 PM.
thank you, its universal lnb for that i am using for D2, following settings allowed me to find channels on D2 but not all (it misses on scanning certain channels)
Here are my settings at the moment:
Configuration Mode: Advanced
Satellite -> D2
LNB -> LNB 2 (LNB 1 is assigned to asat 3s)
Priority -> Auto
LOF -> Universal LNB
Voltage mode -> Polarization
Increased Voltage -> Yes
Tone Mode -> Band
DiSEqc Mode-> 1.0
Toneburst -> none
Committed DiSEqc Command -> AB
Fast DiSEqc -> no
Sequence repeat -> no
Command Order -> committed, toneburst
I thought when I am doing manual scan by keeping "network scan" to yes and "only free scan" to no I should be able to see all the channels even if they are encrypted. It should find few channels at 12519 V;22500;-3/4 but it just passes it without finding anything.
using satfinder I tried to see if I could see anything at 12519V;22500 and to my surprise it shows no SNR but if I change it from V to H then it shows 60% (9.70db). I am pretty sure vertical polarity has the channels and it also confirmed it at lyngsat.
Anyone has any idea what is going on here ?
Last edited by dumb; 26-12-09 at 10:06 AM. Reason: added extra info
Be nice to newbies, they have every right to make mistakes
Thank you everyone,
Flashed DM with Gemini 4.60 image and now everything gets scanned properly.
Be nice to newbies, they have every right to make mistakes
Bookmarks