DM500 PLI image, cccam 2.1
Hi Guys,
My dish setup is as follows:
fox Dish ------ input 3 in disq switch
C band dish ---- input 4 in disq
optus d2 -- unpluged for now
pas8 --- unplugged for now
I tired setting up on my dreambox DM500 but i couldn't get signal,
I went to custom non standered sat settings, but I get stuck at low freq and H freq, and I found the disq options, I chose, version 1.0, and I get AA AB BA BB, and numbers, I tried number 4 and BB no luck for the C band dish, I also tried lnb freq as 05150 for low and high and thresh hold with no luck,
Any ideas what im doing wrong here?
anyone got it working before?
also I ran fox dish on a sperate direct cable and got the picutres fromt he orange card with no problem, but setanta doesnt seem to be working? while it works on my iq box, what do I need to set it up?
Thanks
Look Here -> |
DM500 PLI image, cccam 2.1
What type LNB are you using for the dish you want to set up ?
e.g. 11300, 10700, or Universal
Become a Premium Member and support the Austech Forum
10700 for the fox one
05150 for the Cband one
I have an exact setup to my sever DM500
Firsts things first, are you getting the signal directly to the box.
What I mean is bypass your switch and use ONE LNB input. No aa ab etc.
Get your signal first. Proove it works. Do this for both the 10700 fox and 05150 for the cband.
When using the switch the setup is ONLY the AA AB Ba or BB. NOT 1, 2 ,3 4, etc
Have fox set to BA and your CBand to BB
Turn fox to 'high' and CBand to OFF
10700
10700
10700 for fox
05150
05150
05150 for CBand
Turn any CLines off in your CCcam config (I find it takes a lot longer when switching between sats ) (this is only for your tests etc until you proove it's there and working)
Cheers, Saintaholic
hashoom (30-12-09)
Thats done, The cable was orgonialy plugged in the strong receiver and i was getting signal no issue, and I still do
ok will try that
what about the vloutage? 14v 18v or auto,
also whats fast disq?
Thanks mate, I will try them and report back,
any idea why setanta not working?
all good now, got the signal, thanks so much for that
only problems left is
1- setanta not working on the orange card
2- the orgnal gamma 1.4v running MCSA on intelsat10 the dreambox is not reading it, I tried with jaycar programer and adding some limes according to this
with no luck,
If I buy a dreambox HD will it read the gamma card? no whity, thanks
use /dev/tts/0 not ttyS0
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
thanks mate, will try that tonight,
so no one knows anything about setanta? can I just call setnata and move my sub to the blue card, will that slove my problem?
Last edited by hashoom; 31-12-09 at 01:56 PM.
Bookmarks