hope this helps
I've got a small problem with a EWF1080 Front loader Washing machine,it times out on the first fill of water,gives a E10 code,and reqires a reset button operation to get it to continue filling water and then its alright. I've checked water pressure and had a general look under the bonnet,its either a board fault that has changed a timing thing or a level sensor problem,either way its still works ok after the reset. A service manual would be a real help here to identify things>
Look Here -> |
hope this helps
woteva
Thanks Omega99,I think this has convinced me to part with a bit of cash,the amount of free information that I've got from this site starting from my sat days to now deserves my input.
no worries hope the manual was of help
woteva
Yep,the manual guided me through the tests,without it i would have been lost.
Hi Guys,
I have an EWF1090. I'm guessing the manual applies to it as well??
if not try this one
woteva
treebeard (12-07-10)
Would it be there any chance for EWF1455 as well, please?
this is probably a pretty lame request, but i need to know how to get into this machine to replace the belt, it snapped. i am guessing it cannot be too hard but i do not want to rip apart everything. is there a manual for this machine? thank you in advance Brang
cant help sorry, my samsung threw the belt an i had to cut a hole in the back, stop the wheel wobbling with a new washer and put belt onEfw1090
this is probably a pretty lame request, but i need to know how to get into this machine to replace the belt, it snapped. i am guessing it cannot be too hard but i do not want to rip apart everything. is there a manual for this machine? thank you in advance Brang
where do i find the manual?
Hi,
I'd like to see the EWF 1090 manual also. Where can I find it?
Found it - thanks for posting this online.
IF ANYONE OUT THERE IS SUFFERING THE PAIN OF HAVING THEIR WASHING MACHINE PLAYING UP DUE TO THE E20 CODE ERROR.. I HAVE A SOLUTION FOR YOU YAY!!!!!!!!
WE JUST FIXED OURS YESTERDAY $AVING HUNDREDS OF DOLLARS IN CALL OUT AND REPAIR FEES. ( SMART HUBBY OF MINE) XX
All you have to do is disconnect the power.. lift onto 2 saw horses. Remove the rubber sealed plate at the base( the odd shaped one) and unscrew the drain hose where it meets the front of the washer. the coins will drop out (50c yes) we had four in there .... Reattach the hose.. Replace bottom panel.. then put back on floor.. switch on and presto FIXED 2 people to lift! Hope this helps some people out there!
Hello
Our washing machine has a small tear in the door seal and water simply pours out. Is there any way I could repair the tear (it's on the outer edge... perhaps glue???) or do I need to replace it? Does anyone have any instructions on how to fit a new seal or would I have to pay a repair man? Finally, if it can be saved, does anyone know how to clean up the mould-like build up on parts of the seal (not near the tear)? Cheers...
[QUOTE=treebeard;315131]Hi Guys,
I have an EWF1090. I'm trying to locate the knocking when the washing machine is on the spin cycle, I would like an expolded view of the machine and possible solution to the noise.
thanke for reading
stafford
Last edited by fly2743; 26-12-11 at 08:48 PM.
Bookmarks