Hi,

I have a WD8015C Washer.

It has been tripping the breaker, so i got dad to test it all out and he could not find any issues with earth leakage. we came to the conclusion the Earth Leakage Beaker may have a problem.

I have now been running it for about 3 months with no problems. Last Night when i was doing the load It made a 2 second long Beep and then stopped.

I attended to it and restarted the load on the rinse and spin setting (was up to rinse) and it started, ran for 20 seconds and than stopped again with another 2 second beep.

There where no LEDs flashing or anything. it just switched off.

Is it likely this machine may have a faulty Control board?

My father said the wiring harness is leaking a very small amount to earth when connected to the Line filter, however that is probably because of the capacitors on it and should not be dropping the breaker.

Regards