Results 1 to 3 of 3

Thread: cd/dj mixer

  1. #1
    Member
    Join Date
    Jan 2008
    Posts
    296
    Thanks
    93
    Thanked 21 Times in 18 Posts
    Rep Power
    210
    Reputation
    177

    Smile cd/dj mixer

    Hi there Peoples,


    I have for repair an Audioline cdex2 DJ/CD mixer, which both cd players are not reading the disc. They try to spin up but after about 10 sec "no disc" comes up.

    The laser visually looked weak so I bought a laser ass, which didn't fix the problem. When it is focusing I measured the spindle mtr in milivolts... approx 250mv at TOC.

    Has anyone replaced a servo IC SA9259 before? Are these a common part to replace?


    Just wondering if anyone has a Service Manual for one of these units.

    I rang the company that bring them into Australia (TDJ Australia) and they don't give out the service manual. They are a pack of bums.


    Thanks in advance.



Look Here ->
  • #2
    Senior Member
    mickstv's Avatar
    Join Date
    Jan 2010
    Age
    51
    Posts
    4,173
    Thanks
    2,225
    Thanked 2,404 Times in 1,392 Posts
    Rep Power
    681
    Reputation
    18426

    Default

    Have you checked the Laser wire loom, it could have a hairline fracture. If it uses the white membrane looms.

    Have a close look also and see it the laser is traversing and or the lens moving.





    Mickstv
    Last edited by mickstv; 06-03-11 at 09:34 PM.

  • The Following User Says Thank You to mickstv For This Useful Post:

    aarty (07-03-11)

  • #3
    Member
    Join Date
    Jan 2008
    Posts
    296
    Thanks
    93
    Thanked 21 Times in 18 Posts
    Rep Power
    210
    Reputation
    177

    Default thanks

    thanks for that, I will check it out by substituting from another deck.

    The funny thing is it is a dual system and both mechs have the same issue.

    Both have separate power supply and cd board.

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •