-
DSC PC1550 Disarm after Alarm
Hi want to program a DSC 1550PC which is curently on O/C to disarm after alarm looking at manual
Location 25 I would enter 1 0 1 1
Location 07 make all access codes FF
Location 08 make all acess codes 1 -6 FF and After Alarm Code B plus unsure what to put in 2nd spot
is this correct and what do I put in the After Alarm Code 2 digit section
Thanks
-
I had some problem working this out a while ago and couldn't find much info - so if using contact ID then for a 130 burg put 30 in the 2 digit section the panel adds the 1 in front, So guessing here for an opening 401 put 01. A cancel code is 406 so try 06 although one contact ID listing I just googled has 106 as an unexplained DSC code so maybe the panel is not too smartwhen adding the prefix digits. Like most old panels the lost hours in trying to sort out the programming would have been better invested in a new panel.
Never liked DSC's from the very first time I touched one
Im in agreeance with you guys only worked on two down here they are a rarity but have never been able to find who installed the ones in Tassie
Main panels down here are DAS Ness EDM Tecom Concept C&K , Ademco & MCM and Esprits pop up now and then
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks