Repeat the isolation procedure to de-isolate
Hi Guys, I have a Solution 862 alarm, I have found the instructions in the manual for isolating a zone, I wish to do this because if my heater is alight it sets off my alarm but I cannot find how to remove the isolation??
Look Here -> |
Repeat the isolation procedure to de-isolate
aussiejohn (07-06-12)
When you disarm the alarm it should de-isolate the zone.
aussiejohn (07-06-12)
A"secure" said. The manual isolation is for one arming period only
aussiejohn (07-06-12)
Thanks guys I appreciate the info. Mr Alarm guy why do I need to see the rules I have read them and cannot see what I have done wrong?
aussiejohn (07-06-12)
Hi Guys I have run into another problem with the isolation mode,When I isolate zone 3 by keying in 3*# as soon as the alarm arms itself it goes off
I am trying to do this isolation as I said previously because my wood heater seems to set my alarm off, should this happen?
There are wo ways to isolate depending how it has been programmed.
Code to Isolate - * master code * zone No * #
Standard Isolate - * * zone No * #
When you arm the system the isolated zone will do a steady flash for the exit period.
Yes Watchdog I am doing the standard Isolate...Standard Isolate - * * zone No * # as you state but as soon as I arm the system the alarm goes off!
Is it the zone you are isolating that is setting it off ?
aussiejohn (11-06-12)
I am almost positive it is but I will check it in the morning and repost, cheers
I think from memory you need to enter the zone input as 2 digits, eg 03. If you do it correctly number 3 will begin to flash slowly
aussiejohn (11-06-12)
It'scrowtime, Many thanks, I entered the 03* and tested it just now and it works fine!
Bookmarks