-
How to address 3 LED RAS
Hi, anyone knows how to address the new Tecom 3 LED RAS? The old ones have mdip switches, these new ones do not have any.
The installation tech threw out the instructions that came with it...
-
Junior Member
- Rep Power
- 205
- Reputation
- 70
To configure the RAS:
1. Determine the RAS’s address on the RS-485 LAN (it is
assigned address 16 by default).
2. Connect the RAS to the RS-485 LAN and to power (see
“Connecting the RAS” on page 1).
The RAS will beep once, and the LEDs will flash.
3. Use an LCD RAS to program the Challenger panel or
Intelligent Access Controller to poll RAS 16.
The left LED will display green, and the middle LED will
display orange (unless “LCD arming station” is set to Yes:
it must be set to No).
4. Use the menu option Remote Controllers to access the
RAS menu, and then select the required options, including
the address. See “RAS menu options” below.
5. When finished programming the RAS, exit the RAS menu
to apply the new programming.
6. Poll the RAS at the new address (if applicable).
7. When finished adding readers, de-poll address 16 (if no
longer needed).
The Following User Says Thank You to sirporky For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks