Results 1 to 3 of 3

Thread: Paradox EVO192

  1. #1
    Junior Member Plantagenet's Avatar
    Join Date
    Jan 2008
    Posts
    158
    Thanks
    6
    Thanked 8 Times in 8 Posts
    Rep Power
    204
    Reputation
    50

    Default Paradox EVO192

    Hi all,

    I am testing an EVO192 Paradox console. I am only running a EVO-641 keypad and DGP-ACM12 single door controller off the console's bus.

    Off the ACM12 I am running a ES2200 Padde electronic door strike and Rosslare AYC-E55 keypad.

    I have configured the Rosslare to a the specified site code shown on the microlatch fobs/wiegands. I have also programmed the Rosslare to send keytouches as 5 digit + site code, 26 bit wiegands.

    I have configured the appropriate users and their respective codes (same as the fobs/wiegands) through winload...though when I punch in the 5 digit pins through the Rosslare to try and disarm an arm system, nothing happens. It appecpts the code, beeps and turns green momentarily....then thats it.

    Any advice?

    Thanks for reading.



Look Here ->
  • #2
    Junior Member Plantagenet's Avatar
    Join Date
    Jan 2008
    Posts
    158
    Thanks
    6
    Thanked 8 Times in 8 Posts
    Rep Power
    204
    Reputation
    50

    Default

    No one?

    Mods OK to close. I think these kind of questions should be directed to the manufacturer.

  • #3
    Member
    Join Date
    Jan 2008
    Location
    Melbourne
    Posts
    370
    Thanks
    1
    Thanked 46 Times in 42 Posts
    Rep Power
    220
    Reputation
    596

    Default

    Pin codes should be either 4 or 6 digit.

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •