I recently got a dm800 hd receiver. I have a small dish which has a H-H motor. I previously used the same dish and motor with a strong box, and i could just set it to diseqc 1.2 and move the dish.
The dm800 hd however is not moving the dish. I have tried usals, i have tried diseqc 1.2. Nothing seems to move the dish.
I am using latest Gemini image.
A box as expensive as the dm800 is not able to move the H-H motor. Has anyone here had the same issue, or am i missing a trick?
If anyone has the H-H motor working with dm800 can you please post your configuration or setting details.
Look Here -> |
I do not use Gemini but the setting advanced tab, of diseqc 1.2 it works on all my move 3.2m dishes including a HH motek and at far better speeds than other DM boxes.
I suspect it is a setup issue there. As I use PLi Jade2 update, I can not be of much help other than that sorry. Although it you look at the DM800 wiki for this it might give you a few tips - wiki link in my sig below.
It is a hobby so mileage varies
Loving IPTV with XBMC and android M8
Join in the XBMCHUB community and visit me at http://tvaddons.ag/
thanks for the wiki link. i will have a look. my bigger dish cband with vbox works fine, but the hh motor is not moving. i may have to try another image. can you recommend any good image for dm800 please.
It is a hobby so mileage varies
Loving IPTV with XBMC and android M8
Join in the XBMCHUB community and visit me at http://tvaddons.ag/
Im biased as well, but the latest Jade2 works for driving my sg2100 well in both v1.2 and usals
looks like i need to move from gemini to pli, one last question.
with the latest gemini image i am using, it seems to take an enternity to auto scan or scan a full satellite. is this the same with other images?
is this something because of the dm800 or because of the image i am using?
my dm500 was 50 times faster than this. it takes around 20 mins to scan one full satellite.
It is the same in all images, due to no signal on the transponder being scanned, mostly on the C band. The difference being PLi give you notice of this in the release notes (smile).
It is a hobby so mileage varies
Loving IPTV with XBMC and android M8
Join in the XBMCHUB community and visit me at http://tvaddons.ag/
make sure you dont have tp's that arent sending signal. Ive noticed as well that if your trying to tune a tp that isnt broadcasting it does try and try and try for quite awhile.
is there a spot where you can edit the transponder list for each satellite in dm800?
yes by hand in the satellites.xml file or with dreamedit ..
It is a hobby so mileage varies
Loving IPTV with XBMC and android M8
Join in the XBMCHUB community and visit me at http://tvaddons.ag/
Bookmarks