Yes there was a 3.6 manual and I have no idea why you would install one in your house? Surely you could have come up with a better panel than that?
hi guys
iv just installed a new Eclipse 3.6 alarm system in my house yes it is new and i kno its an old alarm system but been an alarm installer from the early 80s to the 90s i started collecting alarm systems and now that im retired i have loads of alarms in my shed and i found this new Eclipse 3.6 in my shed with 3 new keypads.
now iv installed the system this weekend and its up and all working the only thing is i have only got a Eclipse 2.1 programing manual and not the 3.6 manual and i cant remember if the programing is the same or not so if anyone has a 3.6 manual could you pls let me know i cant remember if there was even a 3.6 programing manual but if someone could help it would be grate thanks guys
Look Here -> |
Yes there was a 3.6 manual and I have no idea why you would install one in your house? Surely you could have come up with a better panel than that?
Hi
I have a manual. I'll try and attach it here. If that doesnt work send me your email address and I'll send it that way.
Paul
You can find the manuals here
oyama (12-08-09)
ah, wonder where they went
Paul
eclipse?
*vomit*
hi guys
thanks Paulypudding and secure for the maunals but something bad happend last night with the alarm.when i installed the 3.6 the service light had been on sins saturday now i hadent tested the sirens or really anything because i went out to cut a long story short the bell fuse had blowen so i turend the alarm off put the new fuse back on nothing happend there was a fault some where on the alarm board when i turned the alarm on after changing the fuse the keypad was on but beeping like mad like it wasent connect to anything turned it off pulled the fuse out turned it back on worked checked the fuse slot one side was + the other was - so there is a fault with the board now i need to try anf fix it tonight will let you guys know what happens
If you pull a fuse out & read across the holder you will see a positive on one side ( incoming power ) and a negative on the other side (via the board circuitry). This is one way of checking the fuse when you have oiss poor eyesight like mine. If the fuse is ok there will be no voltage drop across it.
secure (05-08-09)
Hi guys OK its now dead the panel has stopped working it will run off battery that's it on broad charger is dead and the heat sink gets hot as hell if i plug the power supply in so guys if anyone and i mean anyone has a working Eclipse 3.6 board pls let me know because i really want to have one again that works dont want to uninstall and put in another alarm so if anyone has one pls let me know ill pay up to 50 bucks if some one has one that works
Sounds like you got the a/c plug pack polarity around the wrong way. Swap them leads around and all should be well. The other problem sounds like your EOL resistors have been inserted the wrong way. Take them out and turn them around and you should now get a seal on your zones, but you would of known that previously being an alarm installer. Your offering way to much at $50.00 for a new modern panel. Go to flea bay and buy a $10.00 special and i guarantee you won't be disapointed. You might be able to pick up a DSR module that doesn't even have fuses that need replacing when you do dumb things or needs a keypad to turn off and on.
intelliGEORGE (13-08-09),rotor138 (09-08-09)
lol
At least the tardis doesn't need to reach 85mph to activate!
Make love to a technician today!
Give up on that obsolete crap panel dude
Bookmarks