I have a Concept 2000 (old) that was collected after replacing it with a Tecom system.
Does anybody know how to default the installer code on a 2000?
I vaguely recall something about reversing the memory chip but I also recall being told that you'll fry the chip if you do.
In the past I have had to return a panel to Security Merchants to have the installer code defaulted. Is this the only way?
I think you can default a 1000 installer code by putting (temporarliy) a 2000 memory chip in place but not sure if there is a default procedure for the 2000 or not.
Any suggestions??