According to your diagram - replace 'mux' with Diseqc. It should work fine after that.
hi all..
i have 2 SATs at my house tuned and hence i am currently using 2 seperate recievers...
i have recently aquired a dreambox 7000s and would like to run bot sats of this...
now the Main question is that the Dreambox only have 1 LNB input so i will need some sort of device which switched between LNBs, (like a multiplexer).
here is a diagram to help you understand..
Look Here -> |
According to your diagram - replace 'mux' with Diseqc. It should work fine after that.
your require a diseqc switch.
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
What on earth is that ?
where can i get one ?
Any sat store I would say. Try
It's an electronic switch, that once it's configured in your receiver, will automatically change between LNB's, which in your case are on two separate dishes. When you change channels, the switch will select the dish that's appropriate for that channel...... automatically.
Any satellite equipment supplier should have them.
marty 17 (04-10-09)
so pretty much exactly like a multiplexer ( I am actually an IT person)
ok so it got the diseqc switch installed..
and i have set the parameters as follows in the SAT config..
LNB0.
disec mode 1.0
Diesqc parameter a/a
LNB1
Disec 1.0
Disec Parameter a/b
now my problem is that SAT 1 (optus c1) comes fine i can watch channels ...
but i am unable to switch to sat 2 (asia sat 3) also i need to do a SAT scan as there are NO asiaSat 3 channels...
any help?
also SAt2 LNB is different..
so would i need to change the HI/lo frequencies for it ?
here is what is says ON the LNB.
Edit : Please read this link on how to post a photo. Your original photo was way too big and has been reuploaded to a thumbnail. - Sanity
Last edited by admin; 06-10-09 at 05:04 PM. Reason: As above
ok and you have c1 on a/a and asia sat on a/b connections ??
In your dreambox for your asia sat lnb try 05150 for the first two fields ie LOF/L and LOF/H
you advise worked..
ifirst it tried the first 2 fields as 05150 as u suggested sameproblem..
Then i changed the threshhold to 05150 as well and it works prefectly...
many thanks...
everything is working as it should be now...
Bookmarks