Got the new hose, been re-designed, longer by 3/4" and fits over the small lug on the sump pipe.Lug now locates in a hole.
Must have been a general fault with these dishwashers.
The "y" hose keeps comming of the sump, tried different hose clamps but
they keep comming off.As they tighten the hose slides off the outlet on the sump.It has a step down shoulder which doesnt help
I've ordered a new hose and origional clamp, that's a week away.
Any thoughts as to why it's happening??
Anyone had similar issue??
Look Here -> |
Got the new hose, been re-designed, longer by 3/4" and fits over the small lug on the sump pipe.Lug now locates in a hole.
Must have been a general fault with these dishwashers.
Dishwasher shit itself again - no hot water.
It's a common fault on this model.
The relay that controls the heating element gets extremely hot and melts the solder from its leg(blows out some track in the process)
Some techs were charging for a new PCB $190 part.
Cleaned up the leg, Used solderwick and sweated it in to join back to track.
ALL GOOD.
Hopefully will last a few more years.
Bookmarks