-
Junior Member
- Rep Power
- 173
- Reputation
- 25
Screen calibration error - double din unit
Cheap chinese double din unit. Everything works quite nicely, even have my own systeminformation script for running a gps launcher. However the screen calibration is just a tad off.
When you touch the screen, the input is registered at just below where your finger is. Now this is fine for most of the menus because the icons are huge. However if you run some of the windows ce unitilty stuff the precission needed get higher.
On some full screen applications you cannot close the application because the very top of the screen can't be registered at all. The screen displays correctly, but you can't "touch" the X icon to close the window. If you touch the very top of the screen the input is registered lower.
Is there any way to recalibrate?
-
Junior Member
- Rep Power
- 174
- Reputation
- 65
Somewhere or other there will be a "calibration" menu item to allow you to setup the screen.
Usually in the system setup menu but can be hard to find from one manuf to the next... keep looking, it will be there somewhere
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks