Are you able to input APID, VPID and PCR into your sat receiver? If you blind scan C1 you will not find it otherwise.
Hi
Where do I find Aijzeera on Ku band?
Did read some time back, but have lost it.
thanks
Look Here -> |
Are you able to input APID, VPID and PCR into your sat receiver? If you blind scan C1 you will not find it otherwise.
Optus D3 (so you will need a 10700, or a universal LNB)
12136 V 27800
no need to input pids, these days it usually scans straight in,
Good Luck
Last edited by OSIRUS; 11-12-10 at 06:11 PM.
Become a Premium Member and support the Austech Forum
Thanks to both.
I can put in the values.
Do I still have to change lnb to 10700?
Get it on Sat 5 , but not in english.
Some said it was a good channel to watch.
G'Day Cobber,
All of D3 transponders for Australia are below 12200 and cannot be received with a 11300 LNB.
Just inputting the figure into the STB does not work as the Local Oscillator of the LNB is fixed. The LO frequency is usually written on the LNB and that is what you use in the STB.
Kindest Regards, " the Druid ".
how do i post a tread on her e i can see were to do it anywere
top left hand corner is a button to do just that.
if you go here.
Austech Topics can be found
Last edited by z1gg33; 14-12-10 at 01:14 PM.
If you feed ducks at a pond, chances are your bound to feed a goose or two without even knowing it.
beer4life (14-12-10)
G'Day Cobber,
Go to the main forum info page here:-
From there you can select from the various forums:
From there select a sub-forum,
Then on the lower Nav bar on the left you'll find " New Thread ",
That will open a panel to input your post.
Kindest Regards, " The Druid ".
Bookmarks