Yep, the motor is probably Diseqc 1.2 and the switch Diseqc 1.1
Gidday,
I would like to set my Humax 5410 up for FTA viewing of the Ku suite of satellites using my H-H motor to drive a 90cm dish and also hook it up to a larger dish for C-band stuff.
So, does the Diseqc protocol allow for using a Diseqc switch for multiple LNB's and a Diseqc H-H motor?
Thanks
Porkop
__________________________________________________ __
Statistically, if you wait long enough, everything will happen!
Look Here -> |
Yep, the motor is probably Diseqc 1.2 and the switch Diseqc 1.1
porkop (23-09-10)
Yep that works fine - I have a H-H motor and drive two LNB's. Both LNB's are on the same dish on my setup as shown
Bookmarks