-
Member
- Rep Power
- 211
- Reputation
- 177
cd/dj mixer
Hi there Peoples,
I have for repair an Audioline cdex2 DJ/CD mixer, which both cd players are not reading the disc. They try to spin up but after about 10 sec "no disc" comes up.
The laser visually looked weak so I bought a laser ass, which didn't fix the problem. When it is focusing I measured the spindle mtr in milivolts... approx 250mv at TOC.
Has anyone replaced a servo IC SA9259 before? Are these a common part to replace?
Just wondering if anyone has a Service Manual for one of these units.
I rang the company that bring them into Australia (TDJ Australia) and they don't give out the service manual. They are a pack of bums.
Thanks in advance.
-
Have you checked the Laser wire loom, it could have a hairline fracture. If it uses the white membrane looms.
Have a close look also and see it the laser is traversing and or the lens moving.
Mickstv
Last edited by mickstv; 06-03-11 at 09:34 PM.
The Following User Says Thank You to mickstv For This Useful Post:
Member
- Rep Power
- 211
- Reputation
- 177
thanks
thanks for that, I will check it out by substituting from another deck.
The funny thing is it is a dual system and both mechs have the same issue.
Both have separate power supply and cd board.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks