-
AV-Gad 701 Programming
Hello All
Heading Overseas again and setting up alarm panel.
For some reason a few days before I had some issues and could not disarm so I have reset the system
I have reprogrammed everything else but having issue with the entry delay
When exiting its giving me a chance to exit without any issues.
but when I enter back door the Alarm is not giving me the time to disarm
It is Instant alarm.
I am sure i have set 12 Seconds on Entry delay at address 060 and 061
i have set address 021 as zone 1,2,3,4,5 ( front and back doors and 3 sensors that would trigger on way to panel.
What am I getting wrong.
I am getting into programming mode ok "P" On display
then @021 i have set 1,2,3,4,5
and @ 060 I have 12
System has worked perfect since installed back in 2005 or so
Wish I had the cable and adapter to hook it up via USB running the software ?
Last edited by mutanti; 19-05-12 at 06:09 PM.
-
Well I just came in from Dinner through front door and it worked. Will have to try fron door tomorrow. Thanks Anyways.. :P
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks