Removing an isolated zone

[aussiejohn]

Hi Guys, I have a Solution 862 alarm, I have found the instructions in the manual for isolating a zone, I wish to do this because if my heater is alight it sets off my alarm but I cannot find how to remove the isolation??

[TheAlarmGuy]

Repeat the isolation procedure to de-isolate

[secure]

When you disarm the alarm it should de-isolate the zone.

[watchdog]

A"secure" said. The manual isolation is for one arming period only

[aussiejohn]

Thanks guys I appreciate the info. Mr Alarm guy why do I need to see the rules I have read them and cannot see what I have done wrong?

[TheAlarmGuy]

Thanks guys I appreciate the info. Mr Alarm guy why do I need to see the rules I have read them and cannot see what I have done wrong?

haha thats something i did wrong that the moderators have removed and left that for me to see

[aussiejohn]

Hi Guys I have run into another problem with the isolation mode,When I isolate zone 3 by keying in 3*# as soon as the alarm arms itself it goes off
I am trying to do this isolation as I said previously because my wood heater seems to set my alarm off, should this happen?

[watchdog]

There are wo ways to isolate depending how it has been programmed.

Code to Isolate - * master code * zone No * #
Standard Isolate - * * zone No * #

When you arm the system the isolated zone will do a steady flash for the exit period.

[aussiejohn]

Yes Watchdog I am doing the standard Isolate...Standard Isolate - * * zone No * # as you state but as soon as I arm the system the alarm goes off!

[watchdog]

Is it the zone you are isolating that is setting it off ?

[aussiejohn]

I am almost positive it is but I will check it in the morning and repost, cheers

[itscrowtime]

I think from memory you need to enter the zone input as 2 digits, eg 03. If you do it correctly number 3 will begin to flash slowly

[aussiejohn]

It'scrowtime, Many thanks, I entered the 03* and tested it just now and it works fine!