-
Junior Member
- Rep Power
- 205
- Reputation
- 50
Paradox EVO192
Hi all,
I am testing an EVO192 Paradox console. I am only running a EVO-641 keypad and DGP-ACM12 single door controller off the console's bus.
Off the ACM12 I am running a ES2200 Padde electronic door strike and Rosslare AYC-E55 keypad.
I have configured the Rosslare to a the specified site code shown on the microlatch fobs/wiegands. I have also programmed the Rosslare to send keytouches as 5 digit + site code, 26 bit wiegands.
I have configured the appropriate users and their respective codes (same as the fobs/wiegands) through winload...though when I punch in the 5 digit pins through the Rosslare to try and disarm an arm system, nothing happens. It appecpts the code, beeps and turns green momentarily....then thats it.
Any advice?
Thanks for reading.
-
Junior Member
- Rep Power
- 205
- Reputation
- 50
No one?
Mods OK to close. I think these kind of questions should be directed to the manufacturer.
Pin codes should be either 4 or 6 digit.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks