Results 1 to 2 of 2

Thread: Solution6+6 issue, continously blinking motion sensor

  1. #1
    Junior Member
    Join Date
    Jul 2012
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Reputation
    10

    Default Solution6+6 issue, continously blinking motion sensor

    Hi All,

    I was hoping someone could give me some help with my home alarm. I've recently bought a house with this alarm already installed and I've had some renovation work done which meant a motion sensor was repositioned. This sensor is now blinking continously (4 quick blinks then a 2 second gap). Is there a way to fix this / reset it? If I set the alarm I think it will go off as the control panel says the zone is aways active.

    Many thanks for any help with this,

    Cheers
    Chad



Look Here ->
  • #2
    Member AdRock's Avatar
    Join Date
    Aug 2011
    Posts
    330
    Thanks
    167
    Thanked 45 Times in 43 Posts
    Rep Power
    174
    Reputation
    450

    Default

    Sounds like a stuffed sensor either that or during the repositioning of the sensor the cable may have been damaged and the sensor is continually trying to power up and settle.
    A quick way to check is to put a piece of cardboard over the sensor and see if the light continues to blink, if it does the PIR is faulty and will probably need replacing (and the cabling checked out too)

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •