Results 1 to 5 of 5

Thread: smart card reader

  1. #1
    Junior Member pjjp123's Avatar
    Join Date
    May 2009
    Age
    59
    Posts
    67
    Thanks
    11
    Thanked 2 Times in 2 Posts
    Rep Power
    184
    Reputation
    20

    Default smart card reader

    Whats the programming sequence to disable tampers from smart card readers attached to 4 door controllers on the sub lan,,to unprogram via a ras. thanks in advance.



Look Here ->
  • #2
    Member AdRock's Avatar
    Join Date
    Aug 2011
    Posts
    330
    Thanks
    167
    Thanked 45 Times in 43 Posts
    Rep Power
    174
    Reputation
    450

    Default

    What system? Assuming it's a TECOM since you mentioned RAS. In any event it should be in the manual, have you tried checking that before you post up random stuff like that?

  • #3
    Junior Member pjjp123's Avatar
    Join Date
    May 2009
    Age
    59
    Posts
    67
    Thanks
    11
    Thanked 2 Times in 2 Posts
    Rep Power
    184
    Reputation
    20

    Default

    sorry its a Tecom,,the best I can get from titan help is menu 19 then 28 because the smart card readers are polled as ras's you can have up to 16 on a 4 door controller SUB lan,,if I have 3 x 4 door controllers and 4 readers on each Im guessing its menu 19- then 28- then maybe 17 but the instructions are vague also I will have 4 ras's polled as the same number x 3 ,,so to program out the tamper I need to do it 12 times ? cant seem to do it with titan online.
    Sorry if thats perceived as random but I was just hoping someone would know the programming sequence and lay It out to me better than titan help or the manual which is normally pretty good but in this case doesnt seem to clear.

  • #4
    Junior Member
    Join Date
    Feb 2012
    Posts
    4
    Thanks
    0
    Thanked 1 Time in 1 Post
    Rep Power
    0
    Reputation
    15

    Default

    Personally I didn't think you could, would be glad if someone could tell me otherwise... as I have been fixing tape over the ass end of them for years.

  • The Following User Says Thank You to Xagtho For This Useful Post:

    pjjp123 (01-09-12)

  • #5
    Member
    Join Date
    Jan 2008
    Location
    Melbourne
    Posts
    370
    Thanks
    1
    Thanked 46 Times in 42 Posts
    Rep Power
    220
    Reputation
    596

    Default

    You can follow these instructions:
    19-28-1-DGP Number - 10-2-RAS Number-17 enable\disable RAS tamper.

  • The Following User Says Thank You to kiwitech For This Useful Post:

    pjjp123 (03-09-12)

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •