Originally Posted by
aaron
Hello,
You will find that the message you are getting is that you are not using a version 7.8 or above of the D8/D16 PCB to control the outputs.
In the firmware on the D8/D16 it didn't allow you to control the AUX outputs and from version 7.8 and above it was added so you can.
Although you may have a version 7.8 or above board, and running the aComms app you will find that when you open the app and press the AUX buttons you might get a message saying you don't have the correct version firmware.
If you leave the app open for about 3-4 seconds before pressing the AUX buttons it will work. The app needs to poll the panel to find out what version the D8/D16 is before it sends the command (as it needs to be version 7.8 or above for the command to work) and this poll is the 4th poll in the list.
In the next version (v.1.0.4) there will be a small change and it should fix this problem.
Bookmarks