Activity Stream

This is a good description. Although I'm unsure that a system which requires proof of innocence is desirable in ANYTHING. There isn't a foolproof...

‘Cloned’ number plates are becoming more of an issue than stolen plates. They are cheap to buy online, and when placed on the same make/model/colour...

OK this is one of my pet topics. They will always be at odds because it is home grown as well overseas market dependent. There are far too...

The link I posted discusses installing an app to autostart the TV app on power up, bypassing the cine vision home button Sent from my CPH2437...

The cinavision stuff is embedded in the device firmware ; you'd need a firmware, for that specific hardware, without the embedded 'featureware' in it...

Hi all, Apologies, for late reply... fandtm666 - you might have fixed it 'forever'. However.... Good news: I have managed to get it working...

I am not saying don't report stolen plates. yes it is the responsibility of the owner to report stolen plates. but even if you do report stolen...

have you tried loading the new firware to restore to factory ??? https://forums.whirlpool.net.au/archive/2418355 if you have a ftp program go...

I wish! 6c is the best I get.

It is the responsibility of the car owner to immediately report stolen plates. It is illegal to drive a vehicle without number plates. If a person...

Are you pushing the meter probes through the flux or varnish that might be on the board ?

I get what your saying but thats I dont think your getting what i am saying. Yes it scans the number plate. it doesn't need to know who owns the...

This is the point. Bazzy, I think you are overcomplicating things. In the ACT, the pump is turned on by the console operator who gets...

I think you are missing the point. The servo has to prove that it is your vehicle that did the drive off, not the number plate. Their cameras will...

WHAT?!!! The highest feed in rate I can find from AGL is 15c.

1R0 is the current limiting resistor for the IR Led. I am guessing 1 ohm. So if your reading is correct, it is open circuit. Measure the voltage...

Sorry, Forgot: The components seem to me, in my limited knowledge, ok. Caps are reading ok. All readings are in line - nothing taken out. R's...

Some good info here. https://forums.whirlpool.net.au/archive/2273354 Sent from my CPH2437 using Tapatalk

I was on the 60 cents per Kw for a while but AGL took me off it so I back to 42 Cents until July the 1st 2028. I spoke to a Guy in Europe that had...

Yes I got Greedy and I'm very surprised how good the System works. The Lowest Voltage as it stands is 12.59 Volts during the poor days we had in...

Do you see how insidious that is? Imagine being in a position where your unable to purchase fuel until you take them to the magistrates court or...