The CE versions of XT I had would only work if they could get data from COM or port 1, regardless of what was set in it's settings, 1 was the only port number it would work with.
I used it on a locked Navig8r G43, CE5 device which was locked to port 7.
I used to run a port splitter manually (made a shortcut to start it in the shell I used) set it's input port to 7 & it's output port to 1, before starting XT.
Then XT used to get a signal & work ok almost immediately when started.
I used to only run the CE version of XT from an SD card as it wouldn't work properly from any device's internal storage.
The port splitter never used to matter where it was run from, internal or SD it worked ok.
Bookmarks