-
Junior Member
- Rep Power
- 0
- Reputation
- 10
DAS DL-150 Remote Arm?
Hi All
I'm replacing an old DL-150 with a Hills Reliance R8. I've got most of the cabling identified, except for a blue / white pair which connects to a 2 pin header on the board marked "Remote Arm". The tamper switch of the controller box is in series . The cable pair is part of a 6 wire that goes off to the external horn/strobe (I think). The green/yellow pair of that cable is connected to terminal 1 (marked "Strobe") / common of the DL150 . -Can anyone tell me what I should do with it when trying to hook it up to the new Reliance?
Thanks a lot
Pete
Last edited by big_pierre; 25-05-18 at 10:30 PM.
-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Now I've thought about it, I reckon it must be the going to the tamper switch in the external siren. All good!
Last edited by big_pierre; 26-05-18 at 06:56 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks