-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Bosch D9412GV4 Programing For Network
I have 37 D9412GV4 panels that use the dual phone line module and I want to switch the panels to use the B426 Ethernet module as primary doing away with the dual phone line.
The panels report to a local receiver D6600 and I have installed the ITS-D6686 Ethernet adapter.
I can connect to the receiver using the D6200 software over the network and I can connect to the panels using RPS over the network but can not get the panels to communicate with the receiver.
Any thoughts to what I may have wrong.
-
Junior Member
- Rep Power
- 0
- Reputation
- 15
You'll need to setup the client into the D6200 software before the panel will talk to the receiver.
Junior Member
- Rep Power
- 0
- Reputation
- 10
OK, I purchased the 500 accounts dongle but I still can not get the panel and the receiver to communicate.
I have added the panel in the account database but still get a Comm Fail RTE #1 on the key pad.
Any Thoughts.
Junior Member
- Rep Power
- 0
- Reputation
- 10
Well it's always something simple I had the automation IP address set to the PC running the 6200 software corrected that all is good now.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks