This machine has occasionally stopped part way through its first rinse with 14 minutes to go. It beeps and displays error code 136. On-line wisdom said this fault was a motor stall fault and could be caused by a) sad spin bearings, b) sad position sensor module. Anyway, the washing machine was becoming increasingly noisy during spin(its 20 or more yrs old). So I replaced the spin bearings and the position sensor module. The new position sensor module was a Mk 2 and had a red bracket that I could not work out where it went. The module fitted and locked into the stator the same as the original so I thought no more about it. The machine was reinstalled in the laundry and wife happily reported the machine was no longer trying to escape from the laundry during spin and ran through its cycle. Didn't last long though the machine is again coming up with error 136 and stalling and beeping every two or three washers. Any help would be appreciated. Thanks