Solution 6000 DOTL Programming

[CT4]

I'm sticking a Solution 6000 into a house, self-monitored via MyAlarm IP. Got a garage door with a reed on it that has a report-only DOTL working perfectly. I'd like it to trigger siren/strobe if the the area is armed (and still follow max siren time). Had a play with the macros and also relay to follow zone, but I just can't seem to work it out. I can hard-wire a zone into a physical relay that triggers at the end of the time period and sets off the alarms, but that seems like a waste of a relay. Any suggestions? Thanks!

[jrtech]

Not sure about the Sol6000, DOTL and alarm inputs are processed differently. In most cases we put in 2 reeds on the same door - one for alarm, one for DOTL.

[CT4]

Thanks for the response. I need the delay for DOTL to exist when the system is armed. The delay is 5 mins, which rules out entry/exit delay. Probably much easier to set it up with a relay than with a second reed. I was hoping to do it with phantom relay/zones.