Hi Guys,
I have an NX4 alarm panel, with 3 wired sensors, outdoor light and internal screamer.
Before i pay for a tech to come out, i would like to know if the following is possible on the NX4, as i've heard its possible on the NX8's and above

1 - I would like to make zone 4 a momentary key switch, so i can connect this to a z-wave dry contact relay
2 - have 2 outputs programed, to indicate the state of the panel, One being being armed/disarmed and the other if the strobe light is on/off - i'm assuming these outputs would just be a NO/NC output?

Thanks for your help
Adam