Results 1 to 3 of 3

Thread: Bosch Solution 3000 not triggering siren strobe outputs

  1. #1
    Junior Member
    Join Date
    Aug 2019
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Reputation
    10

    Default Bosch Solution 3000 not triggering siren strobe outputs

    I was installing a Bosch Solution 3000 from Alink and it would not trigger the outputs for the siren and strobe on alarm. The battery was new, fully charged and the siren worked when i manually put 12V on it. The only OP i didnt have connected was the Piezo screamer and the smoke alarm. I was using the slim line style siren strobe unit with LEDs as the strobe.

    I put my meter on the OP and it was showing 2.8V when active, and 12V when not but no sound or strobe. Polarity was confirmed to be correct. Also

    Is there something I missed, or is there a situation where the siren and strobe wont go off or go into a protection mode?
    Could it have been the Siren or strobe gone into some kind of state?
    Does anyone know of a way to set the output to trigger manually for testing from Alink software like you can with the 6000 / Solution link?



Look Here ->
  • #2
    Senior Member secure's Avatar
    Join Date
    Jan 2008
    Location
    W.A
    Posts
    635
    Thanks
    133
    Thanked 109 Times in 96 Posts
    Rep Power
    195
    Reputation
    1557

    Default

    Try power cycling the panel.
    Normally the outputs don't work when low battery detected.

  • #3
    Member
    Join Date
    Oct 2010
    Posts
    319
    Thanks
    14
    Thanked 53 Times in 50 Posts
    Rep Power
    129
    Reputation
    504

    Default

    Post a photo of the PCB connections.

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •