Results 1 to 4 of 4

Thread: Tecom V8 Relay numbering.

  1. #1
    Junior Member
    Join Date
    Nov 2018
    Posts
    18
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Reputation
    10

    Default Tecom V8 Relay numbering.

    I have single door controller connected to V8 Panel.
    The RAS number is 2.
    My question is what is the address of the relay on the RAS2.
    I need to trigger the relay once the card is tapped on the card reader connected to RAS2.



Look Here ->
  • #2
    Banned
    Join Date
    Jan 2008
    Posts
    129
    Thanks
    8
    Thanked 17 Times in 13 Posts
    Rep Power
    0
    Reputation
    260

    Default

    You have to program in a Relay Control Group to RAS2.
    The Relay Control Group (RCG) will corresponded to a Relay Number:
    RCG 1 - Relay 1
    RCG 2 - Relay 9
    RCG 3 - Relay 17
    RCG 4 - Relay 25
    RCG 5 - Relay 33
    RCG 6 - Relay 41

  • #3
    Junior Member Poody's Avatar
    Join Date
    Jul 2010
    Location
    Auckland NZ
    Posts
    145
    Thanks
    0
    Thanked 19 Times in 18 Posts
    Rep Power
    179
    Reputation
    380

    Default

    I always start the numbering at the top end with RCG 32 - Relay 249 and use the same Event flag number if required then work my way back.
    Avoids any conflicts on a growing system.

    Just my bit
    Aspire to Inspire Before you Expire!!

  • #4
    Junior Member
    Join Date
    May 2019
    Location
    Brisbane
    Posts
    45
    Thanks
    0
    Thanked 3 Times in 3 Posts
    Rep Power
    62
    Reputation
    70

    Default

    Just as a reference if you have already sorted it. You don't need to specify a relay control group for the ras UNLESS you want to control the relay with logic or a time zone. Just enable ras 2 into your door group and enable it with a timezone (not the same as the timezone mentioned earlier) and it will just work.

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •