Results 1 to 2 of 2

Thread: NX4v2 - case tamper switch

  1. #1
    Junior Member
    Join Date
    Jan 2008
    Posts
    52
    Thanks
    7
    Thanked 0 Times in 0 Posts
    Rep Power
    146
    Reputation
    10

    Default NX4v2 - case tamper switch

    I am installing a Reliance 8 alarm and wanted to plug in the case tamper switch.

    Would I be right in assuming it doesn't matter which direction I plug the 2 pin tamper switch connector to the J12 pins.

    Also had a question about the fuse on the board.
    I noticed it is soldered on, Is it normal to have them soldered on or is it because I just chose a cheap alarm?

    Any assistance would be appreciated
    thanks



Look Here ->
  • #2
    Senior Member secure's Avatar
    Join Date
    Jan 2008
    Location
    W.A
    Posts
    653
    Thanks
    135
    Thanked 114 Times in 101 Posts
    Rep Power
    198
    Reputation
    1637

    Default

    Doesn't matter which way the tamper connects.

    It may look like a fuse but not sure it actually is.

  • The Following User Says Thank You to secure For This Useful Post:

    taxman (21-10-19)

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •