My mate wanted to put an air horn on the verada so bought one off eBay, deplugged horn rigged air horn up, pressed horn & louder horn. Pressed it again, it stopped. Checked fuse, ok, swapped relay(same value) all good. So I'm looking for a wiring diagram to see what else is on the circuit. Google no help, manuals lab comes up empty. Any ideas please
Sent from my Moto G (5) Plus using Tapatalk
Look Here -> |
There quite possibly more than 1 fuse box
When you press the horn button can you hear a clicking sound inside or in the engine bay.
Death smiles at everyone. Grumpy old men smile back.
is he sure the new horn actually works? did he use an extra relay to drive the new horn?
on the Verada the factory horn is also driven by the ETACs module , it doubles as the car alarm horn.
got to be careful here because on some cars the horn gets its earth from the pissy contacts inside the airbag. any excess current draw will stuff the airbag as well.
yes it would , but the horn contacts are stuck by foil to the outside of the airbag , and a separate circuit , therefore if those contacts fail you need to replace the bag.
also dont forget that the clock spring carries all the current to the horn in some cars so dont do anything to bugger that.
Hi sorry for the delayed reply. Problem solved, the under hoot fuse was blown. Must be the only one I didn't check cause it didn't have the horn symbol. Just goes to show ya have to check them all. Grrrr. Thanks for your help!!!!!
Sent from my Moto G (5) Plus using Tapatalk
Bookmarks