Originally Posted by
mb2
First time setting up a Bosch 3000 (ICP-SOL3-P version 2.0.0).
I've managed to get a B426-M ethernet card working and have been using it to configure the system via the A-Link+ software.
On the link screen is says "Solution 3000_V2.00".
Area 1 status is shown correctly, Area 2 status is shown as invalid (I haven't configured it).
However I don't see any status information for the outputs 1,2 or 3. Instead I see 4 outputs listed and their status is always Invalid.
Nothing is physically connected to any of the 3 outputs.
Do I have to connect a dummy load of some kind so that the alarm panel thinks there is a siren or strobe connected?
Does the relay output count as the 4th output?
Thanks
Mike
Bookmarks