Results 1 to 3 of 3

Thread: C & K Sierra S5030 with LED Keypad

  1. #1
    Junior Member
    Join Date
    Jan 2020
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Reputation
    10

    Default C & K Sierra S5030 with LED Keypad

    Hi

    I have the C & K Sierra S5030 with LED Keypad and currently have the green Power Light flashing and Zone 8 lit.

    I have just recently replaced the old Strobe light and the back up battery, all was working fine up until then.

    Checked the control panel and Zone 8 is setup as the Tamper zone.

    Anyway I can get this tamper code reset?

    Thanks



Look Here ->
  • #2
    Senior Member secure's Avatar
    Join Date
    Jan 2008
    Location
    W.A
    Posts
    907
    Thanks
    156
    Thanked 146 Times in 133 Posts
    Rep Power
    276
    Reputation
    2409

    Default

    Try pressing Cancel for 2 seconds until you hear 2 beeps to clear alarm memory. Or check that zone 8 is sealing, tamper switch closing.

    There is a manual at this link

  • #3
    Junior Member
    Join Date
    Jan 2020
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Reputation
    10

    Default

    I have tried this and the panel is still the same.

    Tamper switch is closed in the control panel.

    Have looked through this manual and tested power and back up battery and these are both fine, so why is the power light still blinking and low battery error still showing?

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •