-
Junior Member
- Rep Power
- 0
- Reputation
- 10
C & K Sierra S5030 with LED Keypad
Hi
I have the C & K Sierra S5030 with LED Keypad and currently have the green Power Light flashing and Zone 8 lit.
I have just recently replaced the old Strobe light and the back up battery, all was working fine up until then.
Checked the control panel and Zone 8 is setup as the Tamper zone.
Anyway I can get this tamper code reset?
Thanks
-
Try pressing Cancel for 2 seconds until you hear 2 beeps to clear alarm memory. Or check that zone 8 is sealing, tamper switch closing.
There is a manual at this link
Junior Member
- Rep Power
- 0
- Reputation
- 10
I have tried this and the panel is still the same.
Tamper switch is closed in the control panel.
Have looked through this manual and tested power and back up battery and these are both fine, so why is the power light still blinking and low battery error still showing?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks