-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Bosch 3000 temporarily disable outputs while installing/testing?
Aside from reassigning siren/strobe/screamer outputs in A-link+ to "output not used", is there an easier way of temporarily disabling them so I don't annoy the neighbours or accidentally damage my hearing?
I thought there would be a jumper on the circuit board or a special test mode but I don't see anything mentioned in the documentation.
-
Just pull the wire out of the output and connect back in when finished.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks